Common causes and solutions of paste box belts slippage in automatic gluing machines|Yonghangbelt sums it up for you

 In operation, the causes of belt slippage in automatic carton gluing machine are many, common causes and solutions are：

Firstly, the friction between the transmission roller and the paste box belt is not enough to cause slippage. Most of the reasons for this are water on the belt or a humid environment. The solution is to add some rosin powder to the pulley. But be careful not to add it by hand, but to blow it into the blower to avoid accidents.

Secondly, starting too fast can also form slippage. You can try to start at a slow speed, pointing twice before starting again, which can also effectively overcome the slipping phenomenon.

Thirdly, the initial tension is too small. When starting, the tension leaving the drum is not enough to cause slippage. The solution is to adjust the tensioning device and increase the initial tension.

Fourth, the load is too large and exceeds the capacity of the motor will also slip. The advantage of slipping at this point is that it plays a protective role for the motor. Otherwise the motor will be burnt out after a long time.

Fifth, the tail roller bearing damage does not turn or the upper and lower rollers bearing damage does not turn too much. The tail of the machine floats and sinks too much, without timely maintenance and replacement has been damaged or rotation inflexible parts, so that the resistance increases causing slippage.

Please contact us direct for more information regarding your specific requirements.

URL:http://www.yhbelt.com

Whatapp&wechat:+ 0086 13725100585

Email :sales@yhbelt.com